Laserfiche WebLink
BRACE AND CARRIAGE BOLT SPECIFICATION <br />&W USSSTANDARD <br />FLAT WASHER <br />vA <br />CONSTRUCTION <br />GRADE NUT <br />COURSE THREAD <br />BRACE <br />L <br />NOTES: <br />uz• cox PLvw000 <br />BRACE <br />M' x 12' CARRIAGE BOLT <br />COURSE THREAD <br />ROUNDED HEAD <br />112'USSSTANDARD <br />FIAT WASHER <br />J <br />ROUNDED HEAD OF W' <br />CARRIAGE BOLT <br />�\ <br />ON WEATHER SIDE OF <br />OPENING <br />YS• HOLE IN BRACE AND <br />PLYWOOD- PRE-ORILLED <br />DURING FABRICATION <br />1. USE 2" BY 4" BY 8' (OR LONGER) CONSTRUCTION GRADE LUMBER FOR BRACES. <br />2. USE 3/8" X 12" CARRIAGE BOLTS - ROUNDED HEAD ON OUTSIDE OF BUILDING <br />3. TIGHTEN NUTS FROM INSIDE ENOUGH TO SLIGHTLY COMPRESS WASHER INTO <br />2X4 BRACE. <br />4. USE 1/2" WASHER ON WEATHER SIDE TO ACCOMMODATE THE WRENCH NECK OF <br />BOLT AND ELIMINATE PRY POINTS. <br />City of Santa Ana RFP 22-068 <br />Page 16 <br />