Laserfiche WebLink
<br />SERVICE AGREEMENT – ALL INCLUSIVE 100% WARRANTY <br />PREVENTATIVE MAINTENANCE SCHEDULE- Maintenance Checklist and Duties Guideline <br />performed by Opal Fuels. <br />Tasks included in PM agreement are done by Opal Fuels factory trained field service technicians. <br />Compressors & Related Equipment <br />Logging <br />• <br />• <br />• <br />• <br />• <br />Log running hours <br />Log temperatures <br />Log suction pressure <br />Log inter-stage pressures <br />Log oil levels and usage <br />Compressors <br />Check oil consumption and oil levels• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />• <br />Check leak rate of mechanical seals <br />Drain effluents from receiver tank <br />Leak check pressurized loop – look and listen for leaks <br />Run to operating conditions; if able <br />Record operating temperatures <br />Record operating pressures <br />Record motor FLA <br />Observe & record unusual conditions <br />Observe compressor control operations <br />Observe priority or buffer fill operation <br />Fill vehicles as available <br />Observe dispenser operations <br />Check gas dryer operations <br />Inspect suction filter; change as required <br />Replace all inter-stage filter elements, as applicable to manufacturers requirements <br />Exchange motion work oil and filter; as applicable and to manufacturers requirements <br />Clean motion work oil strainer during oil changes <br />Inspect clean discharge check valves <br />Check inter-stage check valves for contamination <br />Clean v-belt grooves of flywheel and motor pulleys <br />Check condition of v-belt and belt tension <br />Clean/inspection suction/discharge valves of all stages <br />Grease/lubricate motor bearings <br />Check condensate collecting tank for contamination <br />Check all flexible hoses for signs of deterioration or damage <br />Inspect v-belts for proper wear and alignment <br />Torque all cylinder heads (machine warm and in standstill condition) <br />Dispensers- Fast Fill (if applicable) <br />•Verify on/off switch operations <br />•Visually inspect tubing, piping, and valves for leaks and abnormalities <br />10225 Philadelphia Court <br />Rancho Cucamonga, CA 91730 <br />One North Lexington Ave <br />White Plains, NY 10601 <br />3570 81st Street NW <br />Oronoco, MN 55960