Laserfiche WebLink
<br />Conditions for ADDroval for Variance No. 2005-04 <br /> <br />Variance No. 2005-04 is approved subject to compliance, to the reasonable satisfaction <br />of the Planning Manager, with all applicable sections of the Santa Ana Municipal Code, <br />the California Administrative Code, the Uniform Fire Code, the Uniform Building Code and <br />all other applicable regulations. <br /> <br />The applicant must comply in full with each and every condition listed below prior to <br />exercising the rights conferred by this variance. <br /> <br />The applicant must remain in compliance with all conditions listed below throughout the <br />life of the variance. Failure to comply with each and every condition may result in the <br />revocation of the variance. <br /> <br />A. Plannina Division <br /> <br />1. The project shall remain in compliance with Site Plan Review DP No. 04- <br />96. <br /> <br />2. Any amendment to this conditional use permit must be submitted to the <br />Planning Division for review. At this time, staff will determine if <br />administrative relief is available or the conditional use permit must be <br />amended. <br /> <br />Mitiaation Measures <br /> <br />3. During construction, the contractor is required to comply with SCAQMD <br />Fugitive Dust Rule 403 to suppress dust generated by construction <br />operations. <br /> <br />4. All materials excavated or graded will be sufficiently watered to prevent <br />excessive amount of dust. <br /> <br />5. All clearing and earthwork activities shall cease during period of high <br />winds (winds greater than 25 mph averaged over one hour) or during <br />Stage 1 or Stage 2 smog episodes. <br /> <br />6. Streets surrounding the project site should be cleaned at the end of each <br />day of construction. <br /> <br />7. All materials transported off-site shall either be sufficiently watered or <br />securely covered to prevent excessive amounts of dust. <br /> <br />8. Equipment engines shall be maintained in good condition and in proper <br />tune according to manufacturer's specifications. <br /> <br />EXHIBIT "B" <br /> <br />31A-136 <br />