Laserfiche WebLink
CITY OF SANTA ANA <br /> SPECIFICATIONS <br /> PROJECT NO.: 25-6030 <br /> TRAFFIC SIGNAL INSTALLATION AT SEGERSTROM AVENUE AND ROSEWOOD <br /> AVENUE <br /> Testing of the thermoplastic application rate, as described above, will be required <br /> following any adjustment to the thermoplastic application rate, thermoplastic <br /> applicator nozzles, or any other thermoplastic application equipment prior to <br /> commencement or re-commencement of striping. The initial testing and re-testing <br /> of thermoplastic application rates at any location shall be considered as a single <br /> thermoplastic application rate test for the approved test location. Contractor shall <br /> provide a sample striping test for City approval prior to permanent striping. <br /> Street sweeping of the areas to be re-striped will not be required, but obvious <br /> accumulations of loose material or debris shall be removed prior to application of paint <br /> or thermoplastic. <br /> Thermoplastic material shall be applied to the pavement at a temperature between 400° <br /> F. and 425°F.,unless the manufacturer recommends a different temperature. <br /> Section 84-2.04, "Payment," of the Caltrans Standard Specifications shall be deleted. <br /> F. RAISED PAVEMENT MARKERS <br /> Raised pavement markers shall conform to Section 85, "Pavement Markers," of the <br /> Caltrans Standard Specifications and these Special Provisions. Reflective pavement <br /> markers shall have abrasion-resistant surfaces. <br /> 1. Removal - The contractor shall remove any existing raised pavement markers that <br /> do not conform to the channelization plans, and repair any damaged pavement due <br /> to raised pavement marker removal to maintain a smooth and uniform surface per <br /> SSPWC Section 302-5.6.2. Any missing or broken raised pavement markers shall <br /> be replaced, in kind, within the project boundaries. <br /> 2. Installation - Install raised pavement markers per the channelization plans in <br /> accordance with Section 85-1.06, "Placement," of the Caltrans Standard <br /> Specifications and City of Santa Ana Standard Plans Nos. 1125A- 1125C. <br /> Section 85-1.04, "Payment," of the Caltrans Standard Specifications shall be deleted. <br /> 2.03 SIGNS (ROADSIDE SIGNS)AND MARKERS <br /> This section shall conform to Section 56-2, "Furnish Signs Panels," of the Caltrans <br /> Standard Specifications and these Special Provisions. <br /> A. GENERAL <br /> All new signs shall be furnished and installed by the Contractor. The sign sizes, <br /> messages, and colors shall conform to the current edition of the Caltrans Sign <br /> Specifications. The sign sizes shall be the standard size shown in the Uniform Sign <br /> Chart unless shown otherwise on the plans.The sign backing material shall be anodized <br /> rolled sheet aluminum and shall be one piece with drilled holes for mounting. <br /> 45 <br />