Laserfiche WebLink
CITY OF SANTA ANA <br /> SPECIFICATIONS <br /> PROJECT NO.: 25-6030 <br /> TRAFFIC SIGNAL INSTALLATION AT SEGERSTROM AVENUE AND ROSEWOOD <br /> AVENUE <br /> 8. The mounting hardware for all street name signs shall be Grimco 2SQF12 or <br /> • BA8Al2 or City approved equivalent. <br /> 9. All street names signs shall be installed with bolts through the sign into the <br /> mounting hardware. Compression type of installations will not be accepted. <br /> Reflective sheeting will be applied to the sign panel utilizing the method approved by <br /> the manufacturer of the sheeting and shall produce a durable bond equal to or greater <br /> than the strength of the reflective sheeting. No air pockets or bubbles shall exist <br /> between the sheeting and the aluminum backing. All sign panels furnished by the <br /> Contractor shall be new with no scratches or tears in the reflective sheeting. <br /> No splice will be allowed in the sign panel reflective sheeting other than that which <br /> occurs in the manufactured roll of reflective sheeting on sign panels with a minor <br /> dimension of 48" or less. On all rectangular sign panels, the splice will be horizontal. <br /> No finished sign panel shall have more than one(1)splice and no splice will fall within <br /> 2" of the sign panel edge. When splices do occur, the adjoining reflective sheets shall <br /> be color matched under both incident and reflective light. <br /> Prior to sign installation the contractor will provide a Certificate of Compliance for the <br /> signs. <br /> Section 56-4.02B, Metal Posts, shall be deleted and replaced with the following <br /> paragraph: <br /> New signs shall be installed per City of Santa Ana Standard Plan No. 1504 using <br /> square tubing signpost(such as Unistrut TelsparTM, UltiMate or Agency-approved <br /> equal), anchors and anchor sleeves. Anchors and sleeves shall be embedded with <br /> no more than four holes exposed and no less than two holes exposed. The signpost, <br /> anchor and anchor sleeve shall be fully perforated galvanized square 12 gauge steel <br /> tubing. The signpost shall be 2 inch square,the signpost anchor shall be 2.25 inch <br /> square(all dimensions are nominal). <br /> Section 56-4.02C, "Wood Posts," of the Caltrans Standard Specifications shall be <br /> deleted. <br /> Section 56-4.02D, "Laminated Wood Box Posts," of the Caltrans Standard <br /> Specifications shall be deleted. <br /> The third paragraph of Section 56-4.02E, "Sign Panel Fastening Hardware," of the <br /> Caltrans Standard Specifications shall be amended to read as follows: <br /> All new signs shall be installed with all new mounting hardware. All new straps, <br /> saddle brackets, nuts, bolts, and washers shall be stainless steel and tamper-proof. <br /> Heavy duty banding straps of 0.030 shall be used. Each sign panel shall have a <br /> minimum of two rivets installed per sign. However, signs greater than 45 inches in <br /> height shall have three rivets per sign installed in the top, middle and bottom of the <br /> 47 <br />