Laserfiche WebLink
CITY OF SANTA ANA <br /> SPECIFICATIONS <br /> PROJECT NO.: 25-6030 <br /> TRAFFIC SIGNAL INSTALLATION AT SEGERSTROM AVENUE AND ROSEWOOD <br /> AVENUE <br /> sign. Each signpost shall utilize a minimum of two rivets to attach the sign post to <br /> the sign post anchor assembly. <br /> The fourth paragraph of Section 56-4.02E, "Sign Panel Fastening Hardware," of the <br /> Caltrans Standard Specifications shall be deleted. <br /> C. INSTALLATION AND REMOVAL <br /> Section 56-4.03, "Construction," of the Caltrans Standard Specifications shall be <br /> deleted and replaced with the following: <br /> The Contractor shall install new and relocate existing signs as noted on the plans, <br /> shall protect-in-place existing signs, posts and parking meters which are not to be <br /> removed, and shall replace any of these signs which are damaged during <br /> construction. <br /> Sign to be mounted on streetlight or traffic signal poles shall be installed using the <br /> strap and saddle bracket method as shown on Caltrans Standard Plan RS-4. Sign <br /> panels on traffic signal mast arms shall be installed per Caltrans Standard Plan ES- <br /> 7N, Detail U. Signs mounted on streetlight poles (electroliers) shall be mounted so <br /> as not to cover electrolier identification tags. <br /> Posts shall be installed in driven post anchors per the manufacturer's specifications. <br /> New signs shall be installed on 10 foot posts, except a longer post shall be used if <br /> necessary to maintain a 7 foot vertical clearance from the bottom of the lowest sign <br /> to the top of the surrounding surface in pedestrian areas. Sign posts shall be installed <br /> a minimum of 6 feet from power poles, fife hydrants, and other obstructions. Sign <br /> posts shall be installed per City of Santa Ma Standard Plan No 1504. <br /> All signs to be salvaged, as called for on the plans, shall be become property of the <br /> contractor. <br /> All posts driven sign post anchors shall be completely removed and the sign post <br /> anchor assembly hole backfilled with clean fill dirt to match the existing <br /> surrounding grade(non-paved areas only). Driven sign post anchors in sidewalk or <br /> pavement areas shall be completely removed and backfilled with grout to the level <br /> of the surrounding grade. <br /> Sign posts with foundations in parkway area shall be completely removed and <br /> backfilled with clean fill dirt to match the grade of the surrounding area. Sign posts <br /> located within sidewalk or other paved areas, shall core drill the sidewalk and <br /> remove the sign post to below sidewalk or paving then backfilled with concrete or <br /> paving material to match the existing. <br /> 48 <br />