Laserfiche WebLink
CITY OF SANTA ANA <br /> SPECIFICATIONS <br /> PROJECT NO.: 25-6030 <br /> TRAFFIC SIGNAL INSTALLATION AT SEGERSTROM AVENUE AND ROSEWOOD <br /> AVENUE <br /> Written warranty must be provided by manufacturer for full replacement of the module due <br /> to any failure for a minimum period of fifteen(15) years. <br /> The LED signal module manufacturer shall provide a detailed written warranty issued by the <br /> factory of module origin with the following minimum provisions: <br /> - Modules shall, at the manufacturer's option, be repaired or replaced if the module fails <br /> to function as intended due to workmanship or material defects within the first 15 years <br /> from the date of delivery. <br /> - Modules shall, at the manufacturer's option, be repaired or replaced if the module <br /> exhibit luminous intensities less than the minimum specified values within the first 15 <br /> years of the date of delivery. <br /> 4.23 VEHICLE DETECTORS <br /> Detectors and detector lead-in cable shall conform to the provisions in Section 86- <br /> 1.02F(2)(c)(iii), "Inductive Loop Conductors" Section 86-1.02W, "Loop Detector Sealants," <br /> Section 87-1.03V, "Detectors," Section 87-1.03W, "Sealants," of Caltrans Standard <br /> Specifications and these Special Provisions. <br /> Loop wire shall be per City Std. Plan 1506. <br /> All loop connection shall be in series only. <br /> All new or modified loop curb terminations shall be Type A as shown in CSP ES-5D. Curb <br /> termination conduit shall be 2" (53mm). <br /> If any inductive loop detector wires or loop detector lead-in cables are to be left un- <br /> terminated in a pull box for more than a 24-hour period, the ends shall be securely taped <br /> and sealed with an electrical insulating coating. <br /> 4.24 PEDESTRIAN PUSH BUTTON ASSEMBLIES <br /> Pedestrian push button assemblies shall conform to Section 86-1.02U and 87-1.03U,"Push <br /> Button Assemblies," of the Caltrans Standard Specifications and these special provisions. <br /> Unless shown otherwise on the plans, Pedestrian Push Button shall be Type B <br /> Pedestrian push button assembly shall be ADA compliant furnished with stainless steel <br /> tamper-proof screws.Pedestrian push button assembly shall consist of 5"x7"housing(Color: <br /> Green), 2" ADA Moving Push Button (Color: Green, Button: Silver Stainless Steel) and <br /> Caltrans standard 5" by 7.5" R62D sign. The Pedestrian Push Button Assembly shall be <br /> installed at ADA standard height of 42", measured from top of sidewalk to center of push <br /> button. <br /> 69 <br />