Laserfiche WebLink
[, <br />[ <br /> <br />o <br /> <br />· Checking seals <br /> <br />· Checking inlet vane operator and linkage; lubricating where required <br />Checking the Compressor Oil System for the following items: <br />· Changing oil, oil filter and dryer <br /> <br />· Conducting analysis on oil and oil filter at an independent laboratory <br /> <br />· Checking oil pump, seal and motor <br /> <br /> Cleaning the dirt leg <br /> <br /> Checking heater and thermostat <br /> <br />· Checking all other oil system components including cooler, strainer and <br /> solenoid valve where applicable <br /> <br />Checking Motor Starter and performing the following tasks: <br /> <br />· Running diagnostic check <br /> <br />· Cleaning contacts or recommending replacement <br /> <br />· Checking linkage <br /> <br />· Meging motor <br /> <br />· Checking all terminals and tightening connections <br /> <br />· Checking overloads and dash pot oil <br /> <br />· Cleaning or replacing air filter where required <br /> <br />· Dry running starter (or before start-up); checking status lights <br /> <br />Review the Control Panel for the following items: <br /> <br />· Running diagnostic check of Micro Control Panel <br /> <br />· Checking safety shutdown operation <br /> <br />· Checking all terminals and tightening connections <br /> <br />· Checking Display Data accuracy and set points <br /> <br />Reviewing the Purge Unit for the following items: <br /> <br />· Inspecting the operation of the unit <br /> <br />· Changing oil <br /> <br /> <br />