SIEMENS BUILDING TECH 1 -2003 - Laserfiche WebLink

Home Browse Search

Provide energy savings measure to the existing swimming pool of the facility. The existing pool heating system consists of a boiler, sand filter system and 10-HP pump. The pool operates during the summer and is maintained at 80 deg F. 1. Replace existing heater with more efficient heater 2. Provide a complete and operable system 3. Provide a battery-operated pool cover to cover the pool during unoccupied hours. 4. Provide a complete and operable system Section 15. PRE FIM ASSESSMENT Contactor has performed a detailed feasibility study each of the systems described herein including evaluation, measurements engineering analysis of said systems, following acceptable industry standards and guidelines to predetermine the minimum feasible energy savings and base calculations utilized in Energy Savings Calculations (Exhibit D). Section 16. SPECIAL PROVISIONS RELATED TO THE SCOPE OF WORK. In addition to the specifications detailed herein, Contractor shall provide those special services as described in Attachment 1 to this Exhibit. Section 17. EXCLUSIONS TO THE SCOPE OF WORK A. Contractor shall provide the services described in this Exhibit subject to the following exclusions: 1. Contractor shall not be responsible for repair or replacement of non maintainable or non- moving parts of the system such as ductwork, shell and tubes, heat exchangers, unit cabinets, casings, refractory material, electrical wiring, water and pneumatic piping, structural reports, cooling tower fill, slats and basins, etc. unless otherwise stated in this Agreement. 2. Contractor shall not be responsible for repairs, replacements, or services necessitated by reason of negligence, abuse, misuse, improper or inadequate repairs or modifications, improper operation, lack of operator maintenance or skill, or other reasons beyond our control. 3. Contractor will not assume responsibility for service on equipment unless performed by our employees or persons authorized by us. 4. Contractor shall not be responsible for repairs, replacements or services to equipment due to corrosion, erosion, improper or inadequate water treatment by others, electrolytic action, chemical action or other reasons beyond our control. 5. At initial inspection following 12 months of service, if individual item(s) cannot, in our opinion, be properly repaired, due to obsolescence, lack of availability of refrigerant or standard parts, excessive wear or deterioration, Contractor may withdraw the item(s) from coverage with ninety (90) days prior written notice. 6. Repairs and replacement of equipment parts and components is limited to restoring proper working condition. Contractor shall not be obligated to provide replacement equipment that represents significant betterment or capital improvement. Exchanged parts and components become property of Seimens Building Technologies, Inc. 10