VFS FIRE & SECURITY (BERNEL INC.)

Home Browse Search

SCOPE OF WORK • Test pressure relief valve • Test circulation relieve valve • Record GPM, PSI, RPM, Volts and Amps with pump running at 65%, 100%, and 150% • Test manual crank start • Test on each bank of batteries separately 3. Pump Maintenance • Lubricate pump bearings • Lubricate coupling • Lubricate right-angle gear drive • Calibrate pressure switch settings • Grease motor bearings Maintenance Requests 1. Contractor must be equipped and licensed to perform system maintenance on fire alarm systems, monitoring systems, and related equipment. 2. All work requiring permits or agency notifications, must be handled by the Contractor, prior to the start of the job. 3. The service order must be signed by an authorized Building Maintenance/Park Maintenance employee before contractor leaves the work site in order to explain the completion or suspension of work. If no point of contact is present, please call Phil Neff at (714) 719-2526 or James Riker(714) 719-0067. If no point of contact is present for Park Maintenance, please call Jorge Acevedo at (714) 719-5199 or Eduardo Linares at (714) 647-3523. 4. All work must be authorized by Phil Neff, Facilities Maintenance Manager or a site point of contact before services begin. Clean-Up 1. Maintain the premises free from accumulation of waste materials or rubbish caused by the testing of the fire alarm systems. Carpeting shall be protected from damage and clean-up will be the responsibility of the Contractor. 2. The Contractor shall maintain the job in a clean and orderly fashion. Pick up and remove debris daily. If work under this Contract creates dusty, dirty or unsightly conditions in adjacent areas or occupied areas where work is being performed, the Contractor shall immediately clean up affected areas. Owner reserves the right to clean up affected areas if the Contractor fails to do so, and deduct the cost of the cleanup from the amount owed to the Contractor. City of Santa Ana IFB No. 25-047 Page 19 of 34