Laserfiche WebLink
CITY OF SANTA ANA <br />Proposers shall not submit a copy of a manufacturer's specifications if they differ from the requirements <br />set forth in this document. Additionally, manufacturer or third-party quotations shall not be submitted as <br />a response to the City's bid solicitation. <br />G. HYDRAULIC SYSTEM REQUIREMENTS: All hoses shall be equipped with adequate protective <br />coverings wherever there is potential contact with other components. Separators shall be utilized as <br />necessary. Tape or adhesive fasteners are not permissible. <br />H. FASTENERS: All fasteners shall be grade 5 or better and in some cases grade 8 must be used. <br />Fasteners shall be corrosion resistant and shall utilize a locking nut washer or thread locker <br />wherever possible. Fasteners that are susceptible to corrosion shall be coated with an anti-corrosion <br />compound. <br />I. ELECTRICAL REQUIREMENTS: All hoses and pipes must be routed to avoid heat sources and <br />safeguarded against existing or potential risks of snags, abrasions, or sharp edges. Additionally, all <br />hydraulic hoses, fittings, valves, and piping shall be specifically designed and manufactured for high- <br />pressure hydraulic systems and the intended application in which they are installed. <br />The successful proposer must coordinate with the manufacturer of all electrical accessories to ensure <br />proper multiplexing, wiring, connectors, switches, control panels, and circuit breakers. <br />All upfit wiring connections shall be crimped with solderless connectors, enclosed in shrink tubing with <br />waterproof sealant, and tinned before insertion into component plugs. Chassis grounds will not be <br />accepted-all lighting and auxiliary equipment must have tied-in ground circuits. <br />Upfit wiring must be protected by UV-resistant loom, secured at 10-inch intervals, kept clear of heat <br />sources and snags, and safeguarded by labeled fuses in accessible locations. Wiring routed through tool <br />compartments or canopies must be enclosed in steel or heavy-duty loom. High-voltage electrical <br />components must be routed through weatherproof conduit. <br />J. MANUFACTURER RECALLS: All known open recalls issued by manufacturers or the National Highway <br />Traffic Safety Administration (NHTSA) must be resolved prior to delivery <br />SECTION 2 - HOSTILE VEHICLE MITIGATION MOBILE BARRIER KITS: <br />The mobile barriers and trailers provided under these specifications shall be a standard fleet model and <br />must be listed as the manufacturer's current production model. All equipment must comply with standard <br />model specifications, except where modifications or additions are specified herein. <br />The equipment must be new and unused and capable of operating efficiently in all weather conditions <br />across diverse terrains. Special attention to major components and/or specified critical capacities is <br />mandatory. <br />Equipment to be bid shall include all pedestrian and traffic safety systems available from the manufacturer <br />compatible with future modifications or additional features being installed. <br />ALL CAPACITIES AND RATINGS IN THIS SECTION ARE APPROXIMATE AND INTENDED TO SERVE <br />AS A BASELINE FOR UNIT BEING BID, UNLESS EXPLICITLY STATED AS"SHALL". <br />A. FEDERALGRANT-FUNDEDPURCHASE: <br />Authorized Equipment List (AEL) Numbers: <br />14SW-01-WALL and 12TR-00-TEQP