Laserfiche WebLink
EXHIBIT I <br />CITY OF SANTA ANA <br />REQUEST FOR PROPOSALS FOR LED POST TOP RETROFIT STREETLIGHTS <br />MINIMUM PERFORMANCE REQUIREMENTS FOR SOLID STATE LIGHTING (LED) <br />All luminaires shall be designed as a minimum replacement for either 150W HPS post top luminaire or 70W <br />HPS post top luminaire. It is the City's desire to maintain the historical integrity of the streetlights and reserves <br />the right to waive any of these requirements. Any na deviations p o these minimum requirements must be clearly <br />designated <br />All luminaires shall be SCE preaualified. <br />Warranty <br />1. Written warranty must be provided by manufacturer for full replacement of the luminaire, including <br />labor, due to any failure for a period of seven (7) years. <br />2. Luminaires shall, at the sole discretion of the City, be repaired or replaced if the luminaire fails to <br />function as described in the above specifications for a period of eighty -four (84) months from date of <br />installation. <br />3. Manufacturer shall provide written documentation of its ability to satisfy a catastrophic warranty claim. <br />Luminaire failure rate of fifteen (15) percent shall be considered catastrophic. Any failure to function as <br />specified shall be considered luminaire failure. <br />4. Warranty period shall begin on date of completion. The supplier will provide the City with appropriate <br />signed warranty certificates. The site owner shall receive certificates prior to final payment. <br />Section 1: Retrofit Requirements <br />Proposed Retrofits shall comply with the following requirements: <br />A. General Requirements <br />1. The retrofit manufacturer shall have produced LED retrofits for decorative street light luminaires for a <br />minimum of 5 years at the time of this bid. <br />2 EnerrgIncentive r at the time of this proposal. i <br />Prop seals for prototypes rand conceptual products will not <br />be accepted. <br />3. Proposed products must be able to retrofit all required HID decorative street light wattages, and must <br />be able to fit in a variety of pole configurations. <br />B. Mechanical Requirements <br />1. Heat sinking for the Retrofits and electrical components shall be integral to the Retrofit itself, be passive <br />with no moving or active parts with no moving parts, fans or heat pumps. It shall be shaped to maximize <br />heat movement, and designed so that dirt and debris will not accumulate between fins or channels. <br />2. The Retrofit shall operate in ambient temperatures of -40 °C ( -40 °F) to +40 °C (104 0F). <br />RFP FOR LED POST TOP <br />STRUCTURE LIGHTING Page 124 <br />