SIEMENS MASTER SERVICES - Laserfiche WebLink

Home Browse Search

SIEMENS • Install one (1) outdoor camera mounted on the building viewing the front door entrance. • Install rigid conduit where It is exposed on the exterior of the building within the public reach, or utilize pre-existing conduits. • Install one (1) outdoor loud speaker next to the camera location. • Install Cath cable between the cameras, the loud speakers, and the new IN enclosure. • Install one (1) PTZ camera on the radio pole facing Jerome Center. • Install two (2) Ubiquiti radia links on the rear of the building, one (1) pointed at a Ubiquiti radio link mounted the on the Community Center, one (1) pointed at the ball park public restrooms rooftop. • Install power supplies for camera and radios in the IN room using an existing 120vac circuit. • Install a Cat6 cable for all new devices. Corbin Center • Install rigid conduitwhere it is exposed on the exterior of the building within the public reach, or utilize pre-existing conduits. • Install one (1) fixed camera at the corner ofthe Corbin Center looking Into the alley. • Install Cat6 cable for all new devices. Public Restroom room Building Next to the Ball Field Bleachers • Install one (1) outdoor fixed camera mounted on the building viewing the restroom entrances. • Install one (1) outdoor PTZ camera on the building roof radio pole looking at the bleacher area between the 2 ball fields. • Install one (1) outdoor loud speaker. The location to be determined in the field. • Install rigid conduit where It is exposed on the exterior of the building within the public reach, or utilize preexisting conduits. • Install Cat6 cable between the cameras, loud speaker, and the new IN enclosure. • Install two (2) Ubiquiti radio links on the roof top pole mounted. One (1) radio link will be pointed at a Ubiquiti radio link mounted on the Senior Citizen Center Building, and one (1) pointed at Ubiquiti radio link located next to the baseball field high light pole located to the west of the scoreboard. • Install in the electrical room an IN enclosure and a 120vac quad outlet on a dedicated 20amp circuit. All cabling from the new IDF enclosure shall be in EMT conduit unless it is mounted 10 ft. up the wall, then it may be surface mounted. • Install Cat6 cable for all new equipment Hieh Lieht Pole West of the Scoreboard • Pole mount two (2) Ubiquiti radio links. One (1) pointed at the restroom radio link, and one (1) pointed ata radio link mounted on water pump station. • Pole mount one (1) NEMA enclosure, PoE network switch, and power supplies for the pole mounted equipment • Install Cath OSP cable for all outdoor equipment. • Trench a minimum of 2 ft. deep between the light pole and the Code Blue Tower base. Place in the trench PVC conduits and wire for 120vac 20 amp power and Cat6 (data) from the Code Blue Tower to the pole NEMA enclosure. Install in -ground pull boxes as needed. Where the conduit is exposed to the public use rigid conduit. Backfill the inside of the pull Page 12