SecSol - Laserfiche WebLink

Home Browse Search

B. Relay Sockets: Relay Sockets for 8-pin Relays shall be Idec No. SR2P-06 or approved equal. 2.10 CIRCUIT BREAKERS A. Circuit Breakers: Circuit Breakers shall be single pole, 120 VAC, 20 or 15 Ampere rating or as required to protect wires and equipment mounted inside and powered from the Security Equipment Panel. 2.11 TERMINAL BLOCKS A. Terminal blocks shall be molded plastic with barriers and box lug screw clamp terminals, and shall be rated 15 amperes at 600 volts. White marking strips, fastened securely to the molded sections, shall be provided and wire numbers or circuit identifications shall be marked thereon with permanent marking fluid. Terminal blocks shall be WAGO, Entrelec, Phoenix, or equal. 2.12 SIGNAL AND CONTROL CIRCUIT WIRING A. Wire type and sizes: Conductor within each Security Equipment Panel shall be flexible stranded copper machine tool wire; these shall be UL listed Type MTW and shall be rated 600 volts. Wire for instrument signal circuits, including shielded cables, and alarm input circuit shall be No. 16 AWG. All other wires shall be No. 14 AWG minimum. B. Wire Insulation Colors: Conductors within each Security Equipment Panel supplying 120 volts ac power on the line side of a disconnecting switch shall have a black insulation for the ungrounded conductor. Grounded circuit conductors shall have white insulation. Insulation for ungrounded 120-volt ac control circuit conductors shall be red. All wires energized by a voltage source external to the Control Panel(s) shall have yellow insulation. Insulation for all do conductors shall be blue. C. Wire Marking: Each signal, control, alarm, and indicating circuit conductor, connected to a given electrical point shall be designated by a single unique wire number which shall be shown on all shop drawings. These numbers shall be marked on all conductors at every terminal using white numbered wire markers which shall be plastic -coated cloth, Brady Type B-500, Thomas and Betts "E-Z Code," or equal, or shall be permanently marked heat -shrink plastic. 2.13 SMS SERVER COMPUTER A. One computer shall be provided as the SMS Server Computer. The SMS Sever Computer shall be located in the existing Corporate Yard Control Room Console. The computer shall have a minimum of three 146 GB 10K RPM Ultra SCSI hard disk drives, RAID level 5, a minimum of 3GB DDR2 SDRAM 400MHz, a 20" flat panel color monitor @ .21 mm dot pitch and a minimum 1600 x 1200 resolution. One Ethernet card shall also be provided for the server for connection to the SMS Network. The flat panel type color monitors shall be manufactured by Sony, NEC, DELL or approved equal. The monitor controller shall be provided with a minimum of City of Santa Ana Security Management System Specific Requirements Security Management System Project Page 17100-9 SantaAna_SMS_17100