Laserfiche WebLink
Exhibit A <br />July 23, 2025 <br />22 <br /> <br /> <br />o Close-up(s) of installed pressure regulation/filtration component(s) <br />o Close-up(s) of installed drip tubing <br />x Applicant has attached copies of any project-related receipts or invoices. For a <br />receipt/invoice to be considered eligible it must be: <br />o Typed <br />o Dated within the project period. <br />o Include the address where the work was performed, or materials delivered. <br />o Include the name of the company or contractor providing the service or materials. <br />o Provide a description of the work performed and/or materials purchased, itemized to <br />include make, model, SKU, quantity, price per item, total price. <br /> <br />If the Application is missing or does not comply with the requirements of any of the above, <br />MWDOC/Participant Agency shall work with the applicant to obtain the information and or appropriate <br />photos/documents prior to scheduling the post-inspection. If applicant is unable to provide <br />receipts/invoices that meet the requirements set forth above, the post-inspection will be considered a fail, <br />the application will be denied, no rebate will be issued, and no on-site post-inspection should be <br />scheduled. <br /> <br />If the Application has satisfied all of the above requirements, MWDOC/Participant Agency and/or its <br />inspector will work with Applicant to schedule the mandatory on-site post-inspection. The purpose of the <br />on-site post-inspection is to serve as an independent verification of the information contained in the <br />Application. As part of the on-site post-inspection, Participant Agency/inspector must verify the following: <br />x The actual square footage of the conversion area. All residential Spray-to-Drip sites will be <br />measured using the Moasure device by the Participant Agency and or its inspector for 100% <br />of the sites for 100% of the Spray-to-Drip conversion areas during the post-inspections. <br />The required minimum techniques for area measurements are described in Section V - <br />Measurement Techniques. <br />x That drip irrigation equipment has been installed. For residential on-site post-inspection, <br />if microspray, point-source emitters, or any other type of drip irrigation other than <br />embedded emitter tubing has been installed, this must be noted and photographed. Only <br />embedded emitter tubing installations are eligible for rebates in residential settings. <br /> <br />x That pressure regulation/filtration components have been installed as part of the drip <br />conversion. Manufacturer/make, model, model number/SKU, and quantity should be <br />documented, and the equipment should be photographed. <br /> <br />x That drip tubing has been installed. The drip tubing should be photographed. If covered, <br />a minimum of a 10-foot section must be uncovered for the photograph. <br /> <br />x That spray irrigation is no longer functional in the drip conversion area(s). Any remaining <br />spray heads in the conversion area must be capped (no exceptions). <br /> <br />x That any irrigation ineligible for the rebate, such as spray or bubblers, runs on a separate <br />valve from the eligible drip equipment. <br /> <br />"!#  <br />       <br />